03-07-2011, 04:35 PM
I've had a go at headlights before.
All I did was sand with waterpaper(P400 then P800) soaked in water and a soap of some kind, I would use your regular car wash shampoo, to lubricate. Then followed by SIP on a LC orange pad on my rotary. Results were good but I would suggest maybe using a finer grain sand paper(finer than P800) to finish before polishing to ensure that you remove more scarring caused by the sanding. Especially seeing as you are using a DA.
All I did was sand with waterpaper(P400 then P800) soaked in water and a soap of some kind, I would use your regular car wash shampoo, to lubricate. Then followed by SIP on a LC orange pad on my rotary. Results were good but I would suggest maybe using a finer grain sand paper(finer than P800) to finish before polishing to ensure that you remove more scarring caused by the sanding. Especially seeing as you are using a DA.
![[Image: 3orql10xyr5983zr0vrx.jpg]](http://www.photostand.co.za/images/3orql10xyr5983zr0vrx.jpg)

